FB4C
NOTE: Read the entire instruction manual before starting the
installation.
TABLE OF CONTENTS
SAFETY CONSIDERATIONS
INTRODUCTION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
HEATER PACKAGES
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Step 1 - Check Equipment
Step 2 - Mount Unit
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Step 3 - Air Ducts
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Step 4 - Electrical Connections
Step 5 - Refrigerant Tubing Connection and Evacuation
Step 6 - Refrigerant Flow- -Control Device
Step 7 - Condensate Drains
Step 8 - Accessories
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Step 9 - Sequence of Operation
START- -UP PROCEDURES
CARE AND MAINTENANCE
AIRFLOW PERFORMANCE TABLES
SAFETY CONSIDERATIONS
Improper installation, adjustment, alteration, service, maintenance,
or use can cause explosion, fire, electrical shock, or other
conditions which may cause death, personal injury or property
damage. Consult a qualified installer, service agency, or your
distributor or branch for information or assistance. The qualified
installer or agency must use factory- -authorized kits or accessories
when modifying this product. Refer to the individual instructions
packaged with kits or accessories when installing.
Follow all safety codes. Wear safety glasses, protective clothing
and work gloves. Have a fire extinguisher available. Read these
instructions thoroughly and follow all warnings or cautions
included in literature and attached to the unit. Consult local
building codes and the current editions of the National Electrical
Code (NEC) NFPA 70.
In Canada, refer to the current editions of the Canadian Electrical
Code CSA C22.1.
Recognize safety information. This is the safety- -alert symbol
When you see this symbol on the unit and in instruction manuals,
be alert to the potential for personal injury.
Understand the signal words DANGER, WARNING, and
CAUTION. These words are used with the safety- -alert symbol.
DANGER identifies the most serious hazards which will result in
severe personal injury or death. WARNING signifies hazards
Installation Instructions
PAGE
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . .
which could result in personal injury or death. CAUTION is used
to identify unsafe practices which may result in minor personal
injury or product and property damage. NOTE is used to highlight
suggestions which will result in enhanced installation, reliability, or
operation.
1
!
1
2
ELECTRICAL OPERATION HAZARD
2
Failure to follow this warning could result in personal injury
2
or death.
2
Before installing or servicing unit, always turn off all power to
unit. There may be more than one disconnect switch. Turn off
4
accessory heater power if applicable. Lock out and tag switch
4
with a suitable warning label.
. .
7
7
!
8
9
CUT HAZARD
9
Failure to follow this caution may result in personal injury.
9
Sheet metal parts may have sharp edges or burrs. Use care and
9
wear appropriate protective clothing and gloves when
handling parts.
10
FB4C models are R- -410A Fan Coils designed for installation
flexibility. These units are designed to meet the low air leak
requirements currently in effect.
FB4CNF(018- -048) uses a refrigerant piston metering device. A
TXV is used on FB4CNP(018- -061). All FB4C fan coils use a
multi- -tap ECM motor for efficiency. These units have be designed
for upflow, downflow (kit required), and horizontal orientations,
including manufactured and mobile home applications.
These units require a field supplied air filter, and are designed
specifically for R- -410A refrigerant air conditioners and heat
pumps as shipped. These units are available for systems of 18,000
through 60,000 BTUh nominal cooling capacity. Factory- -
authorized, field - - installed electric heater packages are available in
sizes 5 through 30kW. See Product Data literature for all available
accessory kits.
.
FAN COIL UNITS
FOR R- -410A REFRIGERANT
SIZES 018 TO 061
WARNING
CAUTION
